- 07/13/2019 at 9:34 pm #1440248EduGorillaKeymasterSelect Question Language :
A block of length 200mm is machined by a slab milling cutter 34mm in diameter. The depth of cut and table feed are set at 2mm and 18mm/minute, respectively. Considering the approach and the over travel of the cutter to be same, the minimum estimated machining time per pass is _____________ minutes.
Options :-Post your Training /Course EnquiryAre You looking institutes / coaching center for
- IIT-JEE, NEET, CAT
- Bank PO, SSC, Railways
- Study Abroad